there was an uncaught exception

as you can see in the screen shot, the max results is set as 36.7k only. This value is dependent on your usage left in apify and is set automatically by apify.

but i definitely set it to no max - how do I get it to keep going?

(i have a lot of usage left in apify too so that can't be the issue)

at the time of running the actor, you must be having only 36.7k usage left, then later you must have increase the limit right?

because that value is set by apify automatically based on usage left.

try resurrecting the run.

yep that's right. Just tried resurrecting - didnt work. Any way it can be done? Either I have to start again which I dont want to do because its too slow and I need the data today for a client. Is there a way I can export these, then have it run again but have it ONLY scrape the data from the link that it hasn't already scraped?

currently its fast right now, because there is not much load right now.

you can export these as these are already done.

you can export these out.

okay but once i've exported them out - how do I get the remaining 13k or from the link that haven't been scraped?

*13k or so from the link

if resurrect thing is not working, then its not possible to continue on that run.

in the future - how do I make sure it goes all the way?

after placing the request check the max results on ui. If it''s exactly what you need then its fine, otherwise abort the run and increase your limit or put an apollo link with less leads.

i had max results on unlimited - but youre saying it stopped because i updated my usage after it already started running? so i need to have it set before?

after setting to unlimited, start the run, and check on ui whats the max limit set by apify for that run.

check the max results after starting the run.

if its fine that go ahead otherwise abort it.

okay but if its too low, how do I make the max bigger?

increase your apify usage limit

or upgrade your apify plan

i did that though man - is it because i increased the usage mid way through the run? because if that's not the problem then something else caused it fail

the usage limit should be increased in the start.